How to Install Your Saturday Neon LED Sign with the Standard Flush Mount Screw Kit
This guide will cover the installation of our signs using the standard flush-mount screw kit that accompanies most of the orders we ship. If you purchased your sign with stand-off advertising screws click here. If you plan to install using 3M Command Strips click here. If you plan to install using our Wire Hanging Kit click here.
What You'll Need
- Your Saturday Neon LED Sign
- Flush Mount Screw Kit (Included In The Box)
- Pen, pencil, or marker
- Drill
- Phillips-head screw driver
Step 1: Plan Your Installation Location
- Choose a flat, sturdy surface for mounting your sign.
- Check for nearby power outlets to ensure your sign’s cord can reach.
Step 2: Mark the Mounting Holes
- Hold your sign up to the desired position on the wall.
- Use a pencil to mark through the pre-drilled holes on the sign’s backing.
For larger signs, ask a friend to hold the sign in place while you mark the holes
Step 3: Drill Pilot Holes (Optional)
- For drywall or tougher surfaces:
- Use a drill to create small pilot holes at the marked points. This ensures the screws go in easily and securely.
- If you are not drilling into a stud, consider using drywall anchors to ensure secure installation
Step 4: Secure the Screws
- Align your sign with the marked positions on the wall.
- Feed the screws through the washer and small rubber gasket, and secure the sign to the wall through the pre-drilled holes.
- Tighten screws firmly with a Phillips-head screwdriver, but do not over-tighten to avoid damage.
- Snap the silver cap onto the head of the screws to give a finished look
Step 5: Connect Your Sign
- Plug the USB or standard cord into a power outlet.
- Turn on the switch or use the remote control and enjoy your illuminated sign!
Here is the process visualized in a quick GIF:
